此液压动力单元专为电动篮球架设计,由高齿轮油泵、电机、多用集成块、各式液压阀、油箱等零部件有机组合为一体。构成两条独立的英武的液压上升,重力下降回路,用于篮板和篮球架走轮的升降运动,压力补偿平衡阀的应用使得篮球架走轮的下降动作十分平稳。
This power unit is designed exclusively for the electric-basketball stand,consisting of high pressure gear pump, motor, multi-functional manifold,valves and tank.etc. Constitutes the two independent martial-looking hydraulic pressure rises, the gravity lowering return route, uses in the backboard and basketball stand walks the round vibratory movement, the pressure compensation by-pass valve's application causes the basketball to carry away by force round dro the movement to be very steady.
外型尺寸Outline Dimension 系统工作原理Hydraulic Circuit Diagram
型号规格说明Model Specifications
型号 Model |
电机电压 Motor Volt |
电机功率 Motor power |
油泵排量 Displacement |
溢流阀压力 System pressure |
油箱容量 Tank Capacity |
电磁阀电压 Solenold Valve Volt |
|
RBZ-F1.6B3E42/1 |
220VAC |
0.75KW |
1.6mL/r |
20MPa |
5L |
24VDC |
|
RBZ-E3.7B3G42/1 |
220VAC |
1.5KW |
3.7mL/r |
18MPa |
5L |
24VDC |
|
说明:
1.如需不同流量的泵、压力、电机功率等系统参数,请查看液压动力单元型号说明。
1.Please go to page 1 or consult our sales engineer for the different pump displacement,motor power or tank capacity.
注意事项Special Notes
1.安装前必须保证油缸、油管、接头等液压元件清洁无任何杂质粘附。
1.Clean all the hydraulic parts concemed before mounting the power unit.
2.液压油粘度应为15-68CST,应清洁无杂质,推荐使用N46号液压油。
2.The viscosity of the oil shoud be 15-68 cst.
3.系统使用第一个100小时后,应更换液压油,以后每3000小时更换一次液压油。
3.Change the oil after the first 100 hours of using the power unit,then change the oil every 3000 hours.
4.首次启动运行系统时,应立即检查油箱中的油量是否充足。
4.Check the oil level in the tank after the first star of the power unit.
5.本动力单元适用于水平安装。
5.Mounte the pump station horizontally.